Home Up

 

 
MARINE HOTEL HIK VISION SIGMA SECURITY HDMI POWER LINE HDMI COAXIAL CABLE EXTENDER IPTV ÄĎŃŐÖ. ÄĹĘÔĹÓ ĘÁÔĎĐÔŃÁ ÄÉÁÖĎŃÁ HDMI SPLITTERS

 

     

 

 

 

TELESTE Data Access Hub, DAH100

Teleste's DAH is located closer to end users than traditional CMTS. In terms of capacity it is a step towards full FTTH networks and higher guaranteed bandwidth. It helps operators to segment their networks so that all investments are supporting FTTH network structure when it becomes topical. The MoCA® based indoor solution converts existing indoor coaxial cable networks to Ethernet based IP networks. While most of the home devices have an IP interface instead of traditional RF interface these two technologies can co-exist seamlessly. The solution is using out of band frequencies above UHF frequencies and existing RF services are left untouched. One of the main applications for the solution is an extension of existing indoor WiFi coverage so that every corner in an apartment is a possible door to internet.

RF CHARACTERISTICS


Downstream signal path (RF into RF out)
Frequency range 54 / 85...1006 MHz
Return loss 18 dB
Gain 42 dB
Input attenuator control range 0…25 dB
Input slope control range 0…20 dB
Mid stage slope 0…15 dB
Gain selection 42 / 34 dB
RF modem downstream
Number of channels 16
Output frequency 112…1002 MHz
Output level 95…113 dBµV per channel
Modulation QAM64, QAM256, QAM1024
Channel width 6 MHz / 8 MHz
Flatness ±1.5 dB
Equalized MER 43 dB


Standard Compatible with DOCSIS and euroDOCSIS 2.0 / 3.0
Cable Modems

Flatness ± 0.75 dB
Test point -20 dB
Noise figure 7 dB
CTB 42 channels 117.0 dBěV
CSO 42 channels 117.0 dBěV
XMOD 42 channels 114.5 dBěV
Umax (112 QAM channels) 113.0 dBěV
RF modem upstream
Number of channels 4
Input frequrency 5...42 / 65 MHz
Nominal input level 57…87 dBµV @ 5.12 Mbaud
Type ATDMA, SCDMA
Modulation QPSK, QAM16, QAM64, QAM256
Symbol rate 1.28, 2.56, 5.12 Mbaud / Channel
Channel width 1.6, 3.2, 6.4 MHz
 

Standard Compatible with
DOCSIS and euroDOCSIS 2.0 / 3.0
Cable Modems

GENERAL CHARACTERISTICS


Power consumption 60 W
Supply voltage 110…240 VAC
Dimensions (h x w x d) 360 mm x 350 mm x 150 mm
Weight 10 kg
Class of enclosure IP54
RF connection
Connector, RF in PG11
Connector, RF out PG11
Gigabit ethernet interfaces
Number of ports 3
Connectors 2 x RJ-45 socket, 1 x SFP module slot
Standard 1000BASE-T, 1000BASE-X

Operating temperature -10…+55 ºC
EMC compatibility EN50083-2, EN61000-6-1,

EN61000-6-3

ESD 4 kV
Surge 6 kV (EN 60728-3)
Local management interface (USB port)
Connector USB 2.0

 

Teleste Luminato


video headend platform Teleste Luminato digital headend platform is designed for live content processing. The content can be received from various sources and then descrambled and re-organised into operators’ network for either CATV, OTT and/or IPTV delivery. Cable TV operators and Telco’s of varying sizes and feature demands appreciate Luminato's unparallelled reliability and ease of use

Luminato promo video in Vimeo.com

 
Teleste Luminato Chassis

Teleste Luminato Chassis

Teleste Luminato headend platform is the most compact form factor in the industry with minimal power consumption and cabling requirements. The chassis have been divided into six processing modules. All modules can be hot swapped and auto configured, minimising service outage. The module slots can be equipped with any available Luminato receiver and/or output module.

The two Gigabit Ethernet interfaces with electrical or optical SFP modules are provided for IP payload traffic. MPEG-2 and MPEG-4 with SD, HD and 3D are supported, suitable for IP centric Cable TV, OTT and IPTV networks.

Management of the platform is via a web user interface or CLI (command line interface), providing local or remote access. The advanced DVB stream processing, UDP/IP and RTP/IP streaming and MPTS pass through offers a very flexible environment for service management.

 

 

Teleste Luminato Multireceiver input module

Teleste Luminato quad multi-standard receiver enables flexible selection of free-to-air and scrambled services via DVB-S, DVB-S2, DVB-S2X, DVB-T, DVB-T2, DVB-C, ISDB-T, ITU-T J.83 A/B/C and IP interfaces. Services can be adjusted to match the operators service line-up with built-in advanced transport stream processing capabilities.

•Multiple services per receiver high efficiency, lower investments
•Two physical ports with dual receivers: Several possible input configurations
•Descrambling on all of the inputs
•IP inputs for encrypted or free-to-air content
•Embedded security services cant be accessed in unprotected format
•Hot swap as standard swap the module and keep the configurations
•DVB-S2X reception for efficient high bitrate satellite video
•Advanced transport stream processing
•Demultiplexing from MPTS to SPTS
•PID remapping and filtering
•PSI/SI pass-through or regeneration
•Service follow up, service ID remapping, stream type filtering, SID follow up and service information
•Automatic/manual PSI-SI table generation
•Support for numerous CAS
•Multicast and unicast streaming
•MPTS passthrough
•All input alternatives are enabled with software and available without additional software keys/licenses
•High service availability with input stream redundancy
•Emergency video streaming

Teleste Luminato Application module

Teleste Luminato application module is a complete Linux computer providing an open platform for application development. It is an integral part of Luminato headend platform and enables totally new application possibilities limited only by imagination.

•Complete Linux computer functionality and integral part of the Luminato headend platform
•Open platform for custom-made applications
•Linux OS enables utilizing standard software development tools
•Complete connectivity and interfaces to extensions
•Allows very dense configurations combining headend platform and a compute

 

Teleste Luminato COFDM output module

The dual/quad COFDM output multiplexer for Luminato platform enables flexible multiplexing of SPTS and MPTS video services as well as PSI/SI table streams. High quality DVB-T modulation with agile up conversion provides easy adaptation to DVB-T delivery over HFC-network.

•DVB TS over UDP/IP or RTP/UDP/IP reception
•IP address / UDP port selector for input streams
•Network dejittering
•Advanced transport stream processing
•PCR processing
•Multiplexing
•Automatic PSI/SI table generation
•Custom PSI/SI creation and streaming
•High quality COFDM modulation
•Agile upconversion
•Multiplex IP streaming (VBR or CBR)
•MPEG transport stream over UDP/IP and RTP/UDP/IP streaming

 

Teleste Luminato headend platform is the most compact form factor in the industry with minimal power consumption and cabling requirements. The chassis have been divided into six processing modules. All modules can be hot swapped and auto configured, minimising service outage. The module slots can be equipped with any available Luminato receiver and/or output module.

The two Gigabit Ethernet interfaces with electrical or optical SFP modules are provided for IP payload traffic. MPEG-2 and MPEG-4 with SD, HD and 3D are supported, suitable for IP centric Cable TV, OTT and IPTV networks.

Management of the platform is via a web user interface or CLI (command line interface), providing local or remote access. The advanced DVB stream processing, UDP/IP and RTP/IP streaming and MPTS pass through offers a very flexible environment for service management

 

Send mail to  info{@}satworld.gr with questions or comments about this web site. TEL : 0030 2105778538  
Copyright © 2002 SAT WORLD
Last modified: March 24, 2017